Instruction
Replacement of old air pumps with new air pumps
Note: There is a difference between the installation of the old air pump and the new air pump, you need to replace the bottom bracket of the air pump at the same time and re-punching and tapping, please operate according to your personal situation. ...
Drawing dimensions do not match actual dimensions
Issue Description: In the actual machining process, if you find that the machined dimensions do not match the drawing dimensions, for example, the drawing requires the machining of a 100mm x 100mm square, but the actual machined dimensions are not ...
How to adjust the laser light path
Note: ● When the device leaves the factory, the optical path has been precisely adjusted to the best state. If you are not sure whether the optical path of the device has shifted, please do not adjust the optical path lens knob or locking screw at ...
How to Use the Camera
Attention The camera can only communicate via USB cable. Operation Guide After switching on the machine, connect your computer to the machine using the USB cable and the camera cable. Start the LightBurn software and confirm that the machine is ...
How to Focus
Introduction: The automatic focusing method uses contact-based focusing. Soft materials may affect the focusing accuracy (e.g., sponge, leather). For soft materials, please use manual focusing. You can use 6mm acrylic to make a focusing ruler Manual ...
How to connect external blower
1.Preparation ①. Consumable preparation One Laser X model device*1，M2 hexagon wrench ②. Debug software None 2.Operation step ①Use an M2 hexagon wrench to loosen the six screws on the right side panel and remove the side panel. ②Press the blue air ...
How to adjust the backlash parameters
Note: The reverse clearance of the equipment has been adjusted to the best engraving effect before leaving the factory. Please do not adjust it at will unless you encounter special circumstances. At the same time, the engraving reverse clearance ...
How to switch between different focusing lenses
Note: The XRF & XT series can only switch between 2.0-inch and 2.5-inch focusing lenses. The XT series comes standard with a 2.5-inch focusing lens. The XRF series comes standard with a 2.0-inch focusing lens. Removing the Focusing Lens Remove the ...
One Laser Firmware Upgrade Tutorial
NotNote: Please contact the manufacturer's technicians to obtain the latest version of the firmware program. Before updating the control motherboard, the HMI firmware (i.e. panel firmware) must be updated first. During the firmware update process, ...
How to Adjust the Air Pipe Screw
Note: The screws that fix the air pipe have been adjusted to the best state before leaving the factory. Do not tighten them at will to avoid cutting off the airflow. If you find that there is no airflow during equipment processing, consider adjusting ...
How to Test the Optimal Focal Length
Tools Required RDWorksV8 software、Dot test focal length file、PC data cable、Limestone board Download the Focal Length Test File Right-click the following file and select “Save to File” to save the test file on your computer hard drive. Test the Focal ...
How to Fill Water Tanks
Note: To ensure the normal operation of the One Laser XT model, please note that the cold water pump equipped with this device is used to cool the glass tube. The water in the water tank of the water pump has been drained at the factory. If it is ...
How to Use the Rotary
Due to height restrictions, the rotary needs to be used with an optional base. Operation Step: 1.Remove the fours screws with a 2.5 allen wrench, and take it out. 2.Adjust the drawer installation position according to the height of the rotary and the ...