How to switch between different focusing lenses

How to switch between different focusing lenses

Note: The XRF & XT series can only switch between 2.0-inch and 2.5-inch focusing lenses.

  • The XT series comes standard with a 2.5-inch focusing lens.
  • The XRF series comes standard with a 2.0-inch focusing lens.                                                                                                                                                                              

    Removing the Focusing Lens                                                                                                                                                                                                                        

    1. Remove the front cover of the laser head                                                                                                                                                                                                                   
    2. Remove the focusing lens seat                                                                                                                                                                                        
         
    3. You can use a tool to secure the notches on the ring, then rotate counterclockwise to unscrew the retaining ring, thereby removing the focusing lens.
                                                                                                                                                                                                 

    Installing the Focusing Lens in the Correct Position

    • The focusing lens mount has designated installation positions for both 2.0-inch and 2.5-inch focusing lenses. Install the focusing lens in the correct position according to your needs.
    • The 2.5-inch focusing lens is installed on the top.
    • The 2.0-inch focusing lens is installed at the bottom.

    Note: Only one focusing lens can be installed on the focusing lens mount at a time.

        The focusing lens should be installed with the convex side facing up.                                                                                                                                                               

    • Related Articles

    • How to switch between different focusing mirrors in One Laser Hydra

      Introduction The Hydra series of lasers come standard with a 2.5-inch focusing lens, with optional lenses available in 1.5-inch, 2.0-inch, and 4.0-inch sizes. This document will guide you on how to replace the different sizes of focusing lenses. ...

    • Poor processing effect

      Issue phenomenon： During laser cutting, the material cannot be cut through Operation Guide 1.Material issues The material surface is uneven, coated or has impurities that will affect the cutting effect Make sure the material surface is clean and ...

    • One Laser Hydra Switching Dual Light Source Tutorial

      Note: When configuring dual light sources in the software, make sure that the two lasers are of different types. If the two lasers are of the same type, the motherboard may mistakenly identify them as dual-tube mode, causing both lasers to start ...

    • How to Use the Rotary

      Due to height restrictions, the rotary needs to be used with an optional base. Operation Step: 1.Remove the fours screws with a 2.5 allen wrench, and take it out. 2.Adjust the drawer installation position according to the height of the rotary and the ...

    • How to Focus

      Introduction: l The automatic focusing method uses contact-based focusing. Soft materials may affect the focusing accuracy (e.g., sponge, leather). For soft materials, please use manual focusing. You can make a handful of focusing late using 6mm ...