Setup
The First Time to Run the Machine
Preparation before formally processing documents Before starting processing, please make sure that the equipment is in good condition (i.e. external equipment installation and software connection have been completed). If necessary, please read the ...
Connect XT&XRF To LightBurn Via USB Cable
Operational Guide Install the LightBurn software, please see below link to install. https://docs.lightburnsoftware.com/latest/GetStarted/InstallLightBurn/ Connect your computer and laser machine with a USB cable. Open lightburn and set a connection. ...
Connect XT&XRF To LightBurn Via WiFi
Important Information The WIFI connection can only communicate with the controller, not the camera. WiFi connection is not the most stable method, please choose according to the actual situation. Operation Guide Connect to WiFi Turn on the machine. ...
Connect XT&XRF To LightBurn Via Ethernet
Operational Guide Configure computer 1.Connect the machine and computer with Ethernet cable. 2.Go to Start > Control Panel > Network and Sharing Center, configure the connection for local connection. Like below. 3.Select Properties. 4.In the ...
How to Install the Base for X Series
Understand the Riser Base Assemble the raiser base
Unboxing the X Series
Unbox Step Cut cable tie. After removing the carton packaging, you can move the machine to your workbench. Remove the protective film. Remove all items included and remove the inner foam. Confirm all items. Disassemble the back box and add distilled ...
How to connect the Air Purifier-X series
1.Preparation ①. Consumable preparation One Laser X model device x 1，Air Purifier x 1,Phillips screwdriver x 1 ②. Debug software None 2.Operation step ①.Install the equipment air duct to the air inlet of the purifier Use a cross screwdriver to ...