Install the Base for OneLaser X Series: Step-by-Step Guide

How to Install the Base for X Series

Understand the Riser Base

​

Assemble the raiser base








    • Related Articles

    • Unboxing the X Series

      Unbox Step Cut cable tie. After removing the carton packaging, you can move the machine to your workbench. Remove the protective film. Remove all items included and remove the inner foam. Confirm all items. Disassemble the back box and add distilled ...

    • How to connect the Air Purifier-X series

      1.Preparation ①. Consumable preparation One Laser X model device x 1，Air Purifier x 1,Phillips screwdriver x 1 ②. Debug software None 2.Operation step ①.Install the equipment air duct to the air inlet of the purifier Use a cross screwdriver to ...

    • X-axis motor replacement

      Tools Required M2, M2.5, M3 hexagonal wrenches; M7 open-end spanners; tie wraps; brand new X-axis motor Note: Please complete the following operations in the power-off state, and keep the removed screws properly to avoid losing them Disassembly of ...

    • X axis motor replacement

      Tools to be prepared M3, M2.5 hexagonal wrench, 5MM plum wrench NOTE: Please complete the following operations under power failure and keep the removed screws properly to avoid loss. Disassembling the X-axis motor 1. Unscrew the two right side belt ...

    • Device Disassembly Guide

      Note: When the width of elevator doors, room doors, or other passages is insufficient for the device to pass through, you can disassemble some of the outer shell components to reduce the width requirement for the device. Personnel Requirements: A ...