How to Connect the Air Purifier to OneLaser X Series

How to connect the Air Purifier-X series

1.Preparation

①. Consumable preparation

One Laser X model device x 1，Air Purifier x 1,Phillips screwdriver x 1

②. Debug software

None

2.Operation step

①.Install the equipment air duct to the air inlet of the purifier

  • Use a cross screwdriver to tighten the hose clamp.

②.Connect the purifier to the power supply

​

③Turn on the power of the purifier, start the purifier, and adjust the air volume to the highest.

​


    • Related Articles

    • Unboxing the X Series

      Unbox Step Cut cable tie. After removing the carton packaging, you can move the machine to your workbench. Remove the protective film. Remove all items included and remove the inner foam. Confirm all items. Disassemble the back box and add distilled ...

    • How to Install the Base for X Series

      Understand the Riser Base Assemble the raiser base

    • X Series Glossary

      Front and Rear View 1.Camera This component is used to checking the working status of working area. 2.Laser Head Laser beam comes out from it. 3.Touch Panel This component is used to control the machine, such as movement, run files. 4.PM2.5 Detector ...

    • Replacement of old air pumps with new air pumps

      Note: There is a difference between the installation of the old air pump and the new air pump, you need to replace the bottom bracket of the air pump at the same time and re-punching and tapping, please operate according to your personal situation. ...

    • X-axis motor replacement

      Tools Required M2, M2.5, M3 hexagonal wrenches; M7 open-end spanners; tie wraps; brand new X-axis motor Note: Please complete the following operations in the power-off state, and keep the removed screws properly to avoid losing them Disassembly of ...