Connect XT&XRF To LightBurn Via USB Cable

Connect XT&XRF To LightBurn Via USB Cable


Operational Guide

  1. Install the LightBurn software, please see below link to install.

       https://docs.lightburnsoftware.com/latest/GetStarted/InstallLightBurn/

  1. Connect your computer and laser machine with a USB cable.

 

  1. Open lightburn and set a connection.                                                                                                                                                                                                                            
  1. Select Ruida                                                                                                                                                                                                                                                                                                                                                 
  1. Select Serial/USB                                                                                                                                                                                                                                                                                                                                                  
  1. Name your laser and enter the work area, for X Series, the area is 600×300mm.                                                         
  1. Set the Rear Left as Origin                                                                                                                                                                                                                                                                                                                                                                                                                                                    
  1. Then it's finish.                                                                                                                                                                                                                                                                                                 
  1. Back to the home page and select XT, it's show Ready means the software is connected.                                                                                                          


    • Related Articles

    • Connect XT&XRF To LightBurn Via Ethernet

      Operational Guide Configure computer 1.Connect the machine and computer with Ethernet cable. 2.Go to Start > Control Panel > Network and Sharing Center, configure the connection for local connection. Like below. 3.Select Properties. 4.In the ...
    • Connect XT&XRF To LightBurn Via WiFi

      重要信息 WIFI连接只能与控制器通讯,不能连接相机。 WiFi连接并非最稳定的方式,请根据实际情况选择。 操作指南 连接 WiFi 打开机器。 找到WIFI“VONETS_****”,默认密码为1234567 配置WIFI 登录http://vonets.cfg或者192.168.254.254配置参数,账号密码:admin 选择和你电脑网络匹配的WIFI,点击‘下一步’。 输入WIFI密码,勾选“禁用热点”,点击‘应用’。 点击“连接” 单击开始连接。 然后就连接上了。 点击“重启” 打开 ...
    • Lightburn Software

      Click here to download Lightburn LightBurn is layout, editing, and control software for your laser cutter. With LightBurn you can: Import artwork in a variety of common vector graphic and image formats (including AI, PDF, SVG, DXF, PLT, PNG, JPG, ...
    • The First Time to Run the Machine

      正式处理文件前的准备 在开始加工之前,请先确认设备状态良好(即外部设备安装、软件连接已完成),如有需要,请先阅读以下文章。 https://zohodesk.1laser.com/portal/en/kb/articles/unboxing-the-x-series https://zohodesk.1laser.com/portal/en/kb/articles/connect-xt-xrf-to-lightburn-via-usb-cable 处理步骤 1.开机并连接软件 ...
    • Unboxing the X Series

      Unbox Step Cut cable tie. After removing the carton packaging, you can move the machine to your workbench. Remove the protective film. Remove all items included and remove the inner foam. Confirm all items. Please refer to the items of the tool bag ...