Part Replacement
Cabinet door rebounders replacement
Tools needed 2mm and 2.5mm Allen wrenches, new cabinet door rebounders Note: In the process of replacing the accessories, the removed screws must be properly stored to avoid loss, so as not to affect the subsequent installation. Replacement step 1. ...
Y-axis motor replacement
Tools Required M2, M2.5 hexagonal spanner; tie wraps; steel rule; brand new Y-axis motor Note: Please complete the following operations in the power-off state, and keep the removed screws properly to avoid losing them Disassemble the Y-axis motor 1. ...
X-axis motor replacement
Tools Required M2, M2.5, M3 hexagonal wrenches; M7 open-end spanners; tie wraps; brand new X-axis motor Note: Please complete the following operations in the power-off state, and keep the removed screws properly to avoid losing them Disassembly of ...
Camera Replacement
Tools Required 1.5mm and 2mm Allen wrench, new camera module Remove camera ①. Open the front door cover and loosen the fixing screws on both sides of the camera cover, but there is no need to remove the screws. ②. Remove the camera cover. ③. Unplug ...
Laser Replacement
Note: 1.The following operations should be performed after power disconnection. 2.Please keep the removed screws properly to avoid loss. Disassembly of the Enclosure Both XT and XRF models require disassembly of the casing Use an M2 hex wrench to ...
Replace the control panel
Note: • Before unplugging the cable, please take a photo to record the connection status to prevent incorrect wiring during reinstallation. • Keep the removed screws in a safe place to prevent loss. Tools Required Hex wrenches (M2 & M3), Phillips ...
Control card replacement
Note: • Before unplugging the cable, please take a photo to record the connection status to prevent incorrect wiring during reinstallation. • Keep the removed screws in a safe place to prevent loss. Tools Required Hex wrenches (M2 & M3), Phillips ...
Laser power supply replacement
NOTE: ● Please keep the disassembled screws properly to avoid loss ● Before unplugging the cable, please take a photo to record the connection status to preventincorrect wiring during reinstallation. Tools that need to be prepared Hexagonal wrench ...