Part Replacement
X axis motor replacement
Tools to be prepared M3, M2.5 hexagonal wrench, 5MM plum wrench NOTE: Please complete the following operations under power failure and keep the removed screws properly to avoid loss. Disassembling the X-axis motor 1. Unscrew the two right side belt ...
Y-axis motor replacement
Tools to be prepared M3 hexagonal wrench*1, new Y-axis motor*1 NOTE: Please complete the following operations under power failure and keep the removed screws properly to avoid loss. Removing the Y-axis motor 1. Open the rear door cover of the unit 2. ...
Camera Replacement
Tools to prepare 1.5mm and 2mm Allen wrench, new camera module Remove camera ①. Open the front door cover and loosen the fixing screws on both sides of the camera cover, but there is no need to remove the screws. ②. Remove the camera cover. ③Unplug ...
Laser replacement
Notes: 1.Before operation, the power must be disconnected, otherwise there is a risk of electric shock. 2.Please keep the screws that are removed properly to avoid losing them. Tools Required: Hex wrench,flathead screwdriver,Phillips screwdriver,door ...
Laser Power Supply Replacement
Tools Required One screwdriver, Phillips screwdriver, door cover key The laser power supply is installed at the back of the machine. Note: The power must be disconnected before operation to avoid the risk of electric shock. 1. Glass Tube Laser Power ...
Control panel replacement
Tools that need to be prepared Cross screwdriver Disassemble the control panel Disconnect the power supply of the device Open the front door cover of the device 3. Unscrew the fixing screws of the control panel 4.Remove the control panel and unplug ...
Control card replacement
Tools that need to be prepared Door cover key, cross screwdriver Replacement steps 1. Disconnect the power supply of the device 2. Open the lower right door of the device 3. Disconnect all lines on the control board Note: Please take a photo and ...