Camera Replacement

Camera Replacement

Tools to prepare

1.5mm and 2mm Allen wrench, new camera module

Remove camera

①. Open the front door cover and loosen the fixing screws on both sides of the camera cover, but there is no need to remove the screws.

②. Remove the camera cover.

③Unplug the signal cable of the camera, and then unscrew the 4 screws fixing the camera to take out the camera

 

Installation of camera

①. Fix the brand new camera on the door cover and connect the signal cable

②. Reinstall the camera cover.

NOTE: After completing the camera replacement, you will need to perform the camera calibration manually. The calibration file in the USB flash drive that came with the machine will no longer work.

    • Related Articles

    • Camera Replacement

      Tools Required 1.5mm and 2mm Allen wrench, new camera module Remove camera ①. Open the front door cover and loosen the fixing screws on both sides of the camera cover, but there is no need to remove the screws. ②. Remove the camera cover. ③. Unplug ...

    • How to Use the Camera

      Attention The camera can only communicate via USB cable. Operation Guide After switching on the machine, connect your computer to the machine using the USB cable and the camera cable. Start the LightBurn software and confirm that the machine is ...

    • How to use One Laser Hydra camera

      ntroduction: The purpose of this document is to instruct users on how to connect, calibrate and use the One Laser Hydra series camera. Preparation USB cable*1, PC*1, USB flash drive*1, Lightburn software Connecting the machine and the camera 1. ...

    • Laser replacement

      Notes: 1.Before operation, the power must be disconnected, otherwise there is a risk of electric shock. 2.Please keep the screws that are removed properly to avoid losing them. Tools Required: Hex wrench,flathead screwdriver,Phillips screwdriver,door ...

    • Laser Replacement

      Note: 1.The following operations should be performed after power disconnection. 2.Please keep the removed screws properly to avoid loss. Disassembly of the Enclosure Both XT and XRF models require disassembly of the casing Use an M2 hex wrench to ...