OneLaser X Series Glossary: Key Laser Engraving Terms

X Series Glossary

Front and Rear View


1.Camera

This component is used to checking the working status of working area.

2.Laser Head

Laser beam comes out from it.

3.Touch Panel

This component is used to control the machine, such as movement, run files.

4.PM2.5 Detector

This component is used to detecting temperature, humidity and PM2.5 in the air.

5.Function Panel

This component is used to connect external device and power cable.

6.E-stop

It can rapidly cut off the power supply to the equipment in an emergency.

7.Cooling Fan

This component is used to cooling the rear cover.

8.Exhaust Vent

This component is used to connect the exhaust pipe.


    • Related Articles

    • Unboxing the X Series

      Unbox Step Cut cable tie. After removing the carton packaging, you can move the machine to your workbench. Remove the protective film. Remove all items included and remove the inner foam. Confirm all items. Disassemble the back box and add distilled ...

    • How to connect the Air Purifier-X series

      1.Preparation ①. Consumable preparation One Laser X model device x 1，Air Purifier x 1,Phillips screwdriver x 1 ②. Debug software None 2.Operation step ①.Install the equipment air duct to the air inlet of the purifier Use a cross screwdriver to ...

    • How to Install the Base for X Series

      Understand the Riser Base Assemble the raiser base

    • X-axis motor replacement

      Tools Required M2, M2.5, M3 hexagonal wrenches; M7 open-end spanners; tie wraps; brand new X-axis motor Note: Please complete the following operations in the power-off state, and keep the removed screws properly to avoid losing them Disassembly of ...

    • X axis motor replacement

      Tools to be prepared M3, M2.5 hexagonal wrench, 5MM plum wrench NOTE: Please complete the following operations under power failure and keep the removed screws properly to avoid loss. Disassembling the X-axis motor 1. Unscrew the two right side belt ...