Popular Articles
Connect XT&XRF To LightBurn Via USB Cable
Operational Guide Install the LightBurn software, please see below link to install. https://docs.lightburnsoftware.com/latest/GetStarted/InstallLightBurn/ Connect your computer and laser machine with a USB cable. Open lightburn and set a connection. ...
Device Disassembly Guide
Note: When the width of elevator doors, room doors, or other passages is insufficient for the device to pass through, you can disassemble some of the outer shell components to reduce the width requirement for the device. Personnel Requirements: A ...
Connect XT&XRF To LightBurn Via WiFi
Important Information The WIFI connection can only communicate with the controller, not the camera. WiFi connection is not the most stable method, please choose according to the actual situation. Operation Guide Connect to WiFi Turn on the machine. ...
The First Time to Run the Machine
Preparation before formally processing documents Before starting processing, please make sure that the equipment is in good condition (i.e. external equipment installation and software connection have been completed). If necessary, please read the ...
One Laser Hydra Switching Dual Light Source Tutorial
Note: When configuring dual light sources in the software, make sure that the two lasers are of different types. If the two lasers are of the same type, the motherboard may mistakenly identify them as dual-tube mode, causing both lasers to start ...