Popular Articles
Connect XT&XRF To LightBurn Via USB Cable
Operational Guide Install the LightBurn software, please see below link to install. https://docs.lightburnsoftware.com/latest/GetStarted/InstallLightBurn/ Connect your computer and laser machine with a USB cable. Open lightburn and set a connection. ...
Device Disassembly Guide
Note: When the width of elevator doors, room doors, or other passages is insufficient for the device to pass through, you can disassemble some of the outer shell components to reduce the width requirement for the device. Personnel Requirements: A ...
The First Time to Run the Machine
Preparation before formally processing documents Before starting processing, please make sure that the equipment is in good condition (i.e. external equipment installation and software connection have been completed). If necessary, please read the ...
One Laser Hydra Switching Dual Light Source Tutorial
Note: When configuring dual light sources in the software, make sure that the two lasers are of different types. If the two lasers are of the same type, the motherboard may mistakenly identify them as dual-tube mode, causing both lasers to start ...
Equipment Maintenance Tutorial
Optical Component Maintenance Tools Required Lens cleaning solution、Cotton swabs、Door cover key、Mirror disassembly tool If the provided cleaning solution runs out, it is recommended to use anhydrous ethanol to clean the lenses. To avoid damaging the ...